You do not need every catalogue dimension before contacting EVER POWER. A model marking, clear photo or machine drawing is a useful starting point. The fastest path to a specific pulley quote is to include the belt section, shaft diameter, groove count and speed requirement.
Email [email protected] or use the enquiry form. For replacement work, attach or email a clear view of the pulley face, hub/bush and any visible marking when available.
What to include in your enquiry
| RFQ information | What to send |
|---|---|
| Pulley family / existing model | EP-SPA 200-04, original manufacturer marking or the exact belt profile. |
| Pitch/datum diameter | Use the drawing value if known; if measuring a worn part, also provide outside diameter and a photo. |
| Groove count | Count the active V grooves and identify the belt set. |
| Shaft interface | Shaft diameter, keyway and taper-bush marking/finished bore where present. |
| Driver and driven speed | Motor/engine rpm and target machine rpm. |
| Application | Fan, pump, compressor, agricultural machine, woodworking, textile, food-processing or other equipment. |
| Operating environment | Dust, outdoor exposure, washdown, continuous duty, shock or vibration-sensitive service. |
| Quantity and destination | Required pieces and delivery country for the commercial quotation. |
| Drawing / replacement evidence | Machine drawing, dimensional sketch or clear photographs of the old pulley and bush. |
Three ways to start an RFQ
Direct contact
Sales email
[email protected]
Address
8~10 Ventura Place Dandenong South Victoria Australia 3175
Product support
Browse pulley families
Read technical guides
Enquiry form
Use the configured Fluent Forms enquiry form below. The form is rendered dynamically from the WordPress form ID saved in SPA Site Setup.
RFQ FAQ
I do not know the pulley model. Can I still ask for a quote?
Yes. Send the belt marking, groove count, shaft diameter, measured diameters and clear photos. A machine drawing is even better if available.
Which diameter should I use for the drive ratio?
Use the pitch/datum diameter P. Outside diameter O is mainly useful for physical clearance and replacement identification.
What should I send for a taper-bush pulley?
Send both the pulley marking and the bush marking if visible, plus the shaft diameter and keyway information.
Can I request a non-standard bore or other special requirement?
State the required bore, material/finish, balance or inspection requirement in the RFQ so feasibility can be confirmed for the ordered configuration.
How should I describe a replacement from another standard?
Send the original belt/profile marking and drawing reference. Do not assume a different groove system is interchangeable solely from diameter or appearance.